News

The ADVR-07FH will be used to replace ADVR-07AF and ADVR-07F.
It's 7 Amp AVR with selectable Full-wave / Half-wave output for self-excited brushless generators.
Simply switch DIP SW 3 to select Half-wave or Full-wave output setting, very convenience in use, no need to rewire.
The new design for digital voltage sensing and under frequency protection circuits improve thermal drift performance.

Universal 200 Amp with selectable Full-wave / Half-wave output for self-excited and Carbon Brush Generators. EA200A built-in with high breaking capacity protection MCCB, Automatic/Manual field flashing and fan for cooling and heat dissipation. It also provides Over Temperature Alarm and Over Temperature Shutdown. EA200A has Under frequency protection, Parallel operation and also External emergency stop power generation function.

EC-22 is the upgraded version of EC-02. Instead of AC voltage, the new version use generator "frequency" to determine if engine is successfully start. And EC-22 is specially designed for DENYO generators.

EC-05 is the upgraded version of EC-01. Newly added Choke control makes it more suitable in used for cold regions. It can auto start/stop the Generator remotely with signals from any Automatic Transfer Switch (ATS) controller. Provided with Start, Stop and Choke delay Time setting.

Instead of using Flag terminal connector, the new version of EA448B uses DIP Switch to select sensing input voltage, it’s more flexible in use. EA448B is compatible with Leroy Somer R448, R449 R450 and R438.

ADVR-2300M is the upgraded version of ADVR-2200M.
The sensing voltage has been upgraded from "average reading" to "root mean square (RMS) reading", compatible with Marathon DVR2000 series.

Automatic Voltage Regulator model EA448 is discontinued and the remaining stock will be sold out soon. Model EA448B will be a recommended replacement.

Automatic Voltage Regulator model ADVR-2200M is discontinued and the remaining stock will be sold out soon. Model ADVR-2300M will be a recommended replacement.

Redundant ATS Controller model ATS-34 is discontinued and the remaining stock will be sold out soon. Panel mountable type model ATS-342 will be a recommended replacement.

Portable type Automatic Battery Charger model CH1112/CH1124, CH2112/CH2124 are discontinued and the remaining stock will be sold out soon.
Panel mountable type model CH5612/CH5624 will be a recommended replacement.

BTB Type ATS All-In-One Current Transformer (CT)& Communication Module Load Current display function. Current transformer and KCU Interface module in one. Saves installation space.

Governor Controller model EG4015 is discontinued and the remaining stock will be sold out soon.Model EG4016 will be a recommended replacement.

Working closely with an OEM client, Kutai recently developed a PWM input generator exciter targeted to substitute a traditional AVR control. The exciter module works together with the OEM’s genset control to support several AVR features like soft start, Volt/Hz control, Power factor / kvar control, reactive droop compensation, FRT support to name a few. The bundle is aimed to simplify the operation & troubleshooting and minimize the wiring harness of a reciprocating engine driven generator set.

400Hz AVR release (ADVR-16-400HZ, ADVR-054-400HZ & ADVR-083-400HZ)We have developed and launched a new series of 400HZ Intermediary frequency AVR to fulfill the aviation and military industry’s requirements. These 400HZ AVRs are suitable for output ranges from 5A to 16A, from auxiliary winding to permanent magnet generator PMG type 400Hz generators.

The Kutai Electronics portable automatic battery chargers has always been our customer No.1 choice for unbeatable reliability and consistent performance. However, nowadays with the more and more advanced technologies helping to change the way products are designed and manufactured. Kutai is certain not to fallbehind and aiming to implement all these qualities into our products to improve andupgrade. What is better than improving the already amazing automatic battery chargers.

Kutai Electronics is now on Alibaba

Kutai Electronics is supplying GCU-4K Generator Control Unit and TCS2P125 Automatic Transfer Switch to Japan Kandenko. Japan Kandenko was awarded with Minister of Land, Infrastructure, Transport and Tourism award at The "JECA FAIR 2019-67th Electrical Construction Equipment and Materials Fair" exhibition.

It is always our top priority to better improve our products at all time. Kutai officials have executed planning to upgrade and replace the existing GCU-4K by launching a new advance generator controller called the GCU-5K.

Kutai Electronics has acquired Military spec intermediary 400HZ generator to add toour MG-SET testing stations (Motor driven generator set) These generators are expected to help develop and test the 400HZ AVR developed and manufactured by Kutai Electronics.

Kutai Electronics was invited to participate at the Asia-Pacific Wind Energy Expo.

EC-02 Auto Start Control Unit.
Designed specially to add Auto Start function to DENYO Generators without built-in capability. The module can accept inputs from a remote switch or an Automatic Transfer Switch (ATS) to automatically start and stop the generator.

NCC (National Communication Commission) - South District remotetelecommunication broadcasting tower build supplier. Kutai Electronics is a proud supplier for the telecommunication tower build, providing our advance GCU-4K genset controller and our BTB compact programable automatic transfer switch.

EPMG, an upgrade from the original IVT-1260 and IVT-2460 Generator Auxiliary Excitation Booster, converts DC battery power into a separate excitation source to provide “boost” for self-excited (shunt) generators during heavy transient loads – providing PMG performance for much less cost. Available in 12V (EPMG-1270) and 24V (EPMG-2470).

BTB Type ATS is an integrated transfer switch and controller that is simple and intuitive to operate through a color LCD display panel. The compact back-to-back (BTB) design takes up minimal space and makes installation quick and easy.

Kutai Electronics & MTS Power Products (McPherson Controls) will be participating in a joint exhibition at " POWER-GEN INTERNATIONAL ". Booth: 8327. See you there!
Time: DECEMBER 5 - 7, 2017
Place: LAS VEGAS Convention Center - North & Central Halls, LAS VEGAS, NV USA
Click here for more information http://www.power-gen.com/

Analog / Digital, Single-phase sensing AVR. 7 Amp Full-wave / 5 Amp Half-wave AVR with selectable output for self-excited, brushless generators. Digital voltage sensing and under frequency protection circuits reduce thermal drift.

AVR model EA05AF is discontinued and the remaining stock will be sold out soon. Model ADVR-07AF will be a recommended replacement.

Direct replacement for Newage Stamford AS480. Quadrature Droop Input for Parallel operation. Low frequency protection and soft start voltage ramping.

Light and easy to set, TCS4P125 is an ideal transfter switch with voltage and frequency protection for ATS systems in households or telecommunication stations.

EG3002 is the upgraded version of EG3000 with new Extreme Slow Response function. It also has Smoke Limit and Idle Speed Control when the genset is running.

Electronic Governor Controller model EG3000 is discontinued and the remaining stock will be sold out soon. Model EG3002 will be a recommended replacement.

We thank you for your patronage of KUTAI products. AVR model EA08A & ADVR-08 are discontinued and ADVR-083 will be a recommended replacement.

Designed for different system voltage, the controller is suitable for all the single and three phase low-voltage transfer switch systems in the market. With optional communication modules, users are able to monitor and control the system not only on-site but also remotely via smartphone.

We thank you for your patronage of KUTAI products. ATS-22A ATS Controller is discontinued and ATS-24/ATS-38/ATS-46 will be the recommended replacement.

We thank you for your patronage of KUTAI products. CH1012/CH1024 and CH2012/CH2024 Portable Type Battery Chargers are discontinued and CH1112/CH1124,CH2112/CH2124 or CH4612/CH4624 will be the recommended replacement.

Effectively reduces the temperature drift in self-excited, auxiliary winding, and permanent magnet (PMG) generators. The ADVR-08 can be used in conjunction with the Kutai IVT Auxiliary Excitation Booster.

Kutai has now launched our advanced GCU-4K Auto Start Genset Control & Protection system that features an integrated-design control panel with color touch-screen LCD display allowing the operator to view engine operating conditions and up to fourteen power parameters in either digital or simulated gauge type displays.
GCU-4K users can also download the free Kutai " GenOnCall? " remote monitoring mobile (APP) to carry out remote genset monitoring & operation with any Android or iOS smartphone or tablet computer - for no added cost!

Direct replacement for Newage Stamford AS440. Quadrature Droop Input for Parallel operation, Digital Voltage Sensing and Under Frequency Protection circuits reduce thermal drift.

Kutai Electronics & MTS Power Products (McPherson Controls) will be participating in a joint exhibition at " POWER-GEN INTERNATIONAL ". Booth: 3533. See you there! Time: DECEMBER 13 - 15, 2016
Place: Orange County Convention Center - North & South Halls, Orlando, FL, USA
Click here for more information http://www.power-gen.com/

The New EG4015 Digital Generator Governor Controller uses the detected frequency of the input voltage to precisely control generator engine speed. Requiring no magnetic pickup unit (MPU).

EC-01 Auto Start Module enables a gas generator to be started/stopped remotely with signals from any Automatic Transfer Switch (ATS) controller. Suitable for Honda or Yamaha Gas Generators with Electric Start.

Electronic Governor Controller model EG2000 is discontinued and the remaining stock will be sold out soon. Model EG3000 will be a recommended replacement.

We thank you for your patronage of KUTAI products. AVR model ADVR-053 is discontinued and ADVR-054 will be a recommended replacement

We thank you for your patronage of KUTAI products. CH35 and CH36 Battery Chargers are discontinued and CH46 will be the recommended replacement.

Hybrid analog-digital AVR for self-excited (shunt) generators, with two-line sensing. Compatible with Leroy Somer R250 and can also replace R230, with additional heat removal capabilities for higher reliability.

CH46 Series Intelligent Automatic Battery Chargers designed for Gel, Lead Acid, and AGM batteries. Constant automatic charging ensures your batteries are ready when you need them most. Low battery voltage monitor with alarm output signal available for remote monitoring makes these chargers ideal for standby and remote generators. Available in both 12V and 24V models.

Kutai Electronics & MTS Power Products (McPherson Controls) will be participating in a joint exhibition at " POWER-GEN INTERNATIONAL ". Booth: 4228. See you there!
Time: DECEMBER 8-10, 2015
Place: Las Vegas Convention Center / Las Vegas, NV, USA
Click here for more information
http://www.power-gen.com/

New hybrid analog-digital AVR for self-excited and auxiliary winding generators. Innovative heat sink configuration greatly increases cooling efficiency - reducing the temperature drift and increasing voltage stability.

Innovative heat sink configuration significantly increases cooling efficiency. Effectively reduces the temperature drift in self-excited, auxiliary winding, harmonic winding, and permanent magnet (PMG) generators. The ADVR-08 can be used in conjunction with the Kutai IVT Auxiliary Excitation Booster.